Push-on-Pull Type (Capacity 500MT~1000MT)
▼ Push-on-Pull design is allowed for proper ASTM E-4 calibration even over 450 MT (1 million pounds), enhanced load cell protection, and quicker ram return speeds. The load cell is used in compression type and is placed between the transfer head and the cylinder. Tie-rods then connect the transfer head to the cross head. This design is easier to put the master compression load cell for calibration.
| Model | WPT-500 | WPT-600 | WPT-800 | |
| Capacity – metric tons | 500 | 600 | 800 | |
| Units of measurement | Metric (mm) | Metric (mm) | Metric (mm) | |
| Useful testing length | A | 12000 | 12000 | 12000 |
| Overall length (approx.) | B | 19410 | 19410 | 19910 |
| Overall width (w/o prot. cover) | C | 1958 | 1958 | 2100 |
| Channel width | D | 1138 | 1150 | 1236 |
| Max. testing width | E | 1531 | 1531 | 1623 |
| Overall height (w/ prot. cover closed) | F | 1156 | 1156 | 1319 |
| Overall height (without prot. cover) | G | 828 | 828 | 898 |
| Overall height (prot. cover open fully) | H | 2338 | 2338 | 2678 |
| Standard stroke | I | 1250 | 1250 | 1250 |
| Extra standard length section | 9000 | 9000 | 9000 |
** WIROP® reserves the right to change specifications.